Beeswax wraps are a great way to eliminate or limit plastic use in the kitchen. They make great bowl covers and can even replace ziplock bags! We have some premade in our Kitchen section of the Co-op and at the end of this blog, you can learn how to refresh them and keep them usable!
Wash your wraps with cold water. Using soap and a sponge will cause them to deteriorate faster, so only use if necessary. Often times, rinsing your wrap is enough! Do not use hot water or a scrub brush, it will cause the wax to come off the cloth.
Materials:
- Cotton fabric
- Beeswax pellets or block

Three methods:
- Oven and Cookie sheet
- Paintbrush and Pot or Crockpot
- Parchment Paper and Iron
Cut your fabric into various sizes; 6” X 6”, 8” X 8”, or any special sizes you may need, I have a special 12” X 16” wrap for my 9” X 13” pyrex dish.
Oven and Cookie Sheet method
- If you are using a block, use a cheese grater or knife to finely chop
- Preheat oven to 300F
- Place a wrap or two, however many will fit without touching on your sheet and sprinkle some of the beeswax pellets on top. (see photo)
- Place in the oven for 30-50 seconds, until the pellets have all melted then remove from the oven.
- Do not let the wraps cool on the pan. Carefully pick them up by the corners and place on a cooling rack (cookie cooking rack or collapsable clothes rack workes well).
- Once cooled (which only takes about a minute!) inspect to see if you added enough wax. The wrap should be coated lightly on both sides, with no bare spots.
- I think it is helpful to crumple them in a ball a few times and flatten back out before first use.



Paint Brush and Pot method
Beeswax cools very quickly, this method does not work well in the winter! The wax cools too quickly on the brush. Do this method in a warm place.
- Place the pellets or block in a double boil pot set up or a crockpot.
- Once melted, use a paintbrush to lightly coat both sides of the wrap.
- Once cooled (which only takes about a minute!) inspect to see if you added enough wax. The wrap should be coated lightly on both sides, with no bare spots.
- I think it is helpful to crumple them in a ball a few times and flatten back out before first use.
Parchment Paper and Iron method
- If you are using a block, use a cheese grater or knife to finely chop
- Place a piece of fabric on a piece of parchment paper, sprinkle some pellets on top and then top with another piece of parchment.
- Iron on low for 15-20 seconds or until all the pellets have melted.
- Let them cool for a few seconds then place on a cooling rack (cookie cooking rack or collapsable clothes rack workes well).
- Once cooled (which only takes about a minute!) inspect to see if you added enough wax. The wrap should be coated lightly on both sides, with no bare spots.
- I think it is helpful to crumple them in a ball a few times and flatten back out before first use.
How to Keep your (handmade or store-bought) wraps coated and sticky!
After a while, your wrap will gradually become less stick and have less beeswax coating. You can simply recoat it! The oven or parchment paper and iron methods work the best for re-coating!
Written by Madison Suoja, Education and Outreach Specialist